Skip to main content
Equalizing is an advanced topic, and learning how to do that is beyond the scope of this user manual. Feel free to reach out to us if you have additional questions about this. Please do not randomly change things in the equalizer if you don’t know how to do it. Worst case, you may damage your speaker.

Install the software

The software needed to access the parametric EQ can be downloaded from sigbergaudio.no/manuals. Windows 7 or higher is required. After installing the software, locate the Hypex filter designer (HFD) and launch the software. Connect your speakers to a computer via the included USB cable, and the software will automatically detect your speaker.

Basic instructions for the parametric EQ

The EQ is configured independently for each preset. Each speaker must be EQed individually.
The EQ should be used primarily to reduce peaks caused by room modes in order to achieve a smoother in-room response, not add boost. EQ is most effective below ~500 Hz, but can also be used for broad adjustments higher up, for instance reducing treble in a very reflective room.
1

Open the EQ

With the HFD software active and the speaker connected, click the EQ button in the HFD interface.
2

Add a filter

Click one of the nine circles in the graph or one of the EQ buttons below the graph, and change the desired parameters.
3

Apply the changes

Make sure EQ Enabled is selected, and then click the Upload to DSP button.

Filter parameters

Trying to use all nine filters to perfectly flatten the response isn’t always a good idea. Two or three well placed low Q filters may actually sound best even though the result isn’t perfectly flat.
We strongly advise against adding boost beyond 3 dB.