Install the software
1
Download the software
The software needed to access these settings can be downloaded from sigbergaudio.no/manuals. Windows 7 or higher is required.
2
Launch Hypex filter designer
After installing the software, locate the Hypex filter designer (HFD) and launch the software.
3
Connect the speaker
Connect the speaker to your computer via the included USB cable. The software will automatically detect your speaker.
Auto on/off
Auto on/off is enabled by default. If no input is detected for 60 minutes, the speaker will enter power saving mode. It will automatically wake up again when a signal is detected. Power saving settings and auto on/off sensitivity can be adjusted by changing the Activate signal detection parameters under Device settings. Signal detection level 1 is the most sensitive (default), 4 is the least sensitive.Gain, and auto on/off vs gain
The startup gain of the Saranna may be adjusted with the Volume on start setting. The default value is +3 dB. Different sources have different output levels, which means the default configuration of your Saranna may not work perfectly.Autodetect signal source
By default the amplifier will autodetect signal from any of the inputs. If autodetect is enabled and no input is detected for 15 seconds, the speaker will mute (green LED blinking). If you experience any problems with this feature, autodetect can be disabled on the main screen by changing the Force input setting to the preferred input.This setting is defined independently per preset. If you want to force the input to a specific input for all presets, you have to cycle through all three presets via the Filter preset setting, and configure Force input to your preferred setting on each one.