Skip to main content
Always make sure the loudspeaker is powered OFF before connecting or disconnecting cables.

​
Available connections

​
Analog connection

The easiest way to think of Saranna is as speakers with built-in mono power amplifiers. This means they can be connected to a pre-amplifier or processor with either RCA or XLR stereo outputs, the same way you would with a power amplifier. You can also connect Saranna directly to a source, for instance a network streamer (with volume control). If you need assistance with setting up your system, feel free to contact us. We will be happy to help!

​
Digital connection

When connecting digitally (AES or TOSLINK), both speakers will receive a stereo signal. Your Saranna speakers are preconfigured as a L+R pair that will pick up the individual left or right channel.
1

Find the left and right speaker

Inspect the serial number label on the rear of the speaker. The identical serial numbers will end with “L” and “R” respectively.
2

Place the speakers

Place the speaker labeled “R” as the right speaker, and the speaker labeled “L” as the left speaker.

​
Check the channel configuration

Press the select button on the speaker and hold it for 3 seconds. Either “Left”, “Right” or “Left+Right” will light up to indicate the current configuration.

​
Change the channel configuration

If you wish to change the configuration, or accidentally did so: press the select button for three seconds and keep pressing. The configuration will change and cycle through “L”, “R” and “L+R” every 1.5 seconds. It can also be done using the HFD software. See Adjusting defaults.